阵列卡报错代码.docx

CodeMeaningRecommended Action1702SCSI cable error detected. System halted.This message indicates a termination or cabling problem with the system board integrated SCSI controller. Check Cabling and termination1720Slot x Drive Array – S.M.A.R.T. Hard Drive Detects Imminent Failure: SCSI Port x: SCSI ID xThe indicated drive has reported a S.M.A.R.T. predictive failure condition, and may fail soon. Do not replace the drive unless all other drives on the array are on-line! Back up data before replacing drive(s).1721Slot x Drive Array – Drive Parameter Tracking Predicts Imminent Failure. The following device(s) should be replaced when conditions permit:Do not replace drive unless all other drives on the array are on-line! Back up data before replacing drive(s). MP predictive failure threshold exceeded condition. The indicated drive may fail at some time in the near future.1723Slot x Drive Array – to improve signal integrity, internal SCSI connector should be removed if external drives are attached to the same SCSI port (followed by further details).Follow the remaining instructions in the POST message.1724Slot x Drive Array – Physical Drive Position Change(s) Detected – Logical drive configuration has automatically been updated. (RESUME = F1 KEY)This message indicates that logical drive configuration has been updated automatically following physical drive position changes. Select F1 key to resume.1725Slot x Drive Array – Optimal SIMM (Memory Module) problem detected (followed by one of the following):· ????????SIMM has automatically been disabled due to memory errors·?????????Unsupported SIMM type installed. Use 4MB Fast70ns Tin-Lead.Remove or replace the problem SIMM. This message is specific to SMART-2SL controllers.1726Slot x Drive Array - Array Accelerator Memory Size Change Detected – Array Accelerator configuration has automatically been updated (RESUME = F1 KEY)This message appears if the controller is replaced with a model that has a different amount of cache mem