USB Device Class 详解.docVIP

USB Class Codes December 7, 2011 From:/developers/defined_class USB defines class code information that is used to identify a device’s functionality and to nominally load a device driver based on that functionality. The information is contained in three bytes with the names Base Class, SubClass, and Protocol. (Note that ‘Base Class’ is used in this description to identify the first byte of the Class Code triple. That terminology is not used in the USB Specification). There are two places on a device where class code information can be placed.One place is in the Device Descriptor, and the other is in Interface Descriptors. Some defined class codes are allowed to be used only in a Device Descriptor, others can be used in both Device and Interface Descriptors, and some can only be used in Interface Descriptors. The table below shows the currently defined set of Base Class values, what the generic usage is, and where that Base Class can be used (either Device or Interface Descriptors or both). Base Class Descriptor Usage Description 00h Device Use class information in the Interface Descriptors 01h Interface Audio 02h Both Communications and CDC Control 03h Interface HID (Human Interface Device) 05h Interface Physical 06h Interface Image 07h Interface Printer 08h Interface Mass Storage 09h Device Hub 0Ah Interface CDC-Data 0Bh Interface Smart Card 0Dh Interface Content Security 0Eh Interface Video 0Fh Interface Personal Healthcare 10h Interface Audio/Video Devices DCh Both Diagnostic Device E0h Interface Wireless Controller EFh Both Miscellaneous FEh Interface Application Specific FFh Both Vendor Specific Base Class 00h (Device) This base class is defined to be used in Device Descriptors to indicate that class information should be determined from the Interface Descriptors in the device. There is one class code definition in this base class. All other values are reserved. This value is also us