机械诱导金属表面再生层性能分析-中国表面工程.PDFVIP

第 29 卷 第 6 期 中 国 表 面 工 程 Vol. 29 No. 6 2016 年 12 月 CHINA SURFACE ENGINEERING December 2016 doi: 10.11933/j.issn.1007−9289.2016.06.018 机械诱导金属表面再生层性能分析 黄书林，杨 屹，杨 刚，刘 剑，周 宇 ( 四川大学 制造科学与工程学院，成都 610065) 摘 要: 利用羟基硅酸盐减磨、再生的摩擦学特性，通过机械摩擦磨损诱导金属(45钢)表面生成一层再生层。用扫描 电子显微镜表征再生层的厚度，并用能谱分析仪和X射线光电子能谱仪分析再生层的元素组成和化学状态，用维氏硬 度仪和洛氏压痕法测试其显微硬度和表层结合力。结果显示：当添加剂羟基硅酸盐质量分数为10.5%时，金属磨损量 最小，再生层厚度最大；再生层主要含有C、O、Fe 、Cr等4种元素，这些元素以石墨碳和金属氧化物形式存在；对再 生层进行力学性能测试，再生层维氏硬度为648.8 HV0.3 ，为基体的1.7倍；表层结合力临界载荷Pc约为150 kg，与基体 结合性能好。 关键词: 羟基硅酸盐；摩擦磨损；润滑脂；再生层；厚度 中图分类号: TG115.58 文献标志码: A 文章编号: 1007−9289(2016)06–0129–07 Performance Analysis on Restoration Layer of Metallic Surface Induced by Machinery HUANG Shu-lin, YANG Yi, YANG Gang, LIU Jian, ZHOU Yu (School of Manufacturing Science and Engineering, Sichuan University, Chengdu 610065) Abstract: Using the tribological properties of the hydroxyl silicate anti-attrition and restoration, and the restoration layer of 45-steel surface induced by mechanical friction and wear was generated. The thickness of the layer was investigated by scanning electron microscopy (SEM), the composition and chemical state of element of the restoration layer were analyzed by energy dispersive spectrometry (EDS) and x-ray photoelectron spectrometry (XPS), and microhardness and adhesion strength were tested by Vickers hardness tester and Rockwell indentation method. Results show that weigh loss is the least and the thickness of the restoration layer is the thickest when the content of the additive hydroxyl silicate is 10.5%. The restoration layer is compos