cad常用变量kca（CAD common variable KCa）.docVIP

cad常用变量kca（CAD common variable KCa） By bear The variable CAD system can also use the electrical design of these... But enough... ^_^ A ACADLSPASDOC system variable Type: integer Location: save the registry Initial value: 0 AutoCAD control is to load the acad.lsp file to all the graphics, the first figure or only loaded into the AutoCAD task in the open. 0 only the first graphic acad.lsp is loaded into the AutoCAD task in the open 1 acad.lsp will be loaded to each open graph A FLAGS system variable Type: integer Dont be saved Initial value: 0 Set the ATTDEF property code symbol. This value is the following optional code and value: 0 Non selected attribute pattern 1 invisible 2 fixed 4 verification 8 preset Four ANGBASE system variables Type: real Location: Graphics Initial value: 0 Relative to the current UCS reference angle is set to 0 degrees Five ANGDIR system variables Type: integer Location: Graphics Initial value: 0 Setting angle direction. Measuring the angle from 0 angles relative to the current value of the UCS direction. 0 counterclockwise 1 clockwise Six APBOX system variables Type: integer Location: Registry Initial value: 0 Open or close the AutoSnap target frame?. When capturing object, target frame display in the center of the cross cursor. 0 does not show the target frame 1 shows the target frame Seven APERTURE system variables Type: integer Location: Registry Initial value: 10 In pixels set the target frame display size. The target frame is using the selection tool drawing commands. Eight ATTDIA system variables Type: integer Location: Registry Initial value: 0 The INSERT command is used to control the input dialog attribute value. Please refer to the INSERT command line. 0 given command prompt 1 the use of the dialog box Nine ATTMODE system variables Type: integer Location: Graphics Initial value: 1 Display control attribute. 0: all the attributes are not visible. 1: to maintain visibility of each attribute at present: display visible properties sho