TUB AND SHOWER VALVES Moen（浴缸和淋浴阀摩恩）.pdf

下载文档

8
0
约2.21万字
约 4页
2017-09-03 发布于浙江
举报
版权申诉
保障服务

TUB AND SHOWER VALVES Moen（浴缸和淋浴阀摩恩）.pdf

1、本文档共4页，可阅读全部内容。
2、有哪些信誉好的足球投注网站（book118）网站文档一经付费（服务费），不意味着购买了该文档的版权，仅供个人/单位学习、研究之用，不得用于商业用途，未经授权，严禁复制、发行、汇编、翻译或者网络传播等，侵权必究。
3、本站所有内容均由合作方或网友上传，本站不对文档的完整性、权威性及其观点立场正确性做任何保证或承诺！文档内容仅供研究参考，付费前请自行鉴别。如您付费，意味着您自己接受本站规则且自行承担风险，本站不退款、不进行额外附加服务；查看《如何避免下载的几个坑》。如果您已付费下载过本站文档，您可以点击这里二次下载。
4、如文档侵犯商业秘密、侵犯著作权、侵犯人身权等，请点击“版权申诉”（推荐），也可以打举报电话：400-050-0827(电话支持时间：9:00-18:30)。

TUB AND SHOWER VALVES Moen（浴缸和淋浴阀摩恩）

MODELS 2290, 2291, 2600, 2700, 5401, 62600, 62700, 72615, 72700 MT620J and MODEL SERIES T471, T473, T555, T666, T777 T888  ® INSTALLATION INSTRUCTIONS THESE INSTRUCTIONS MUST BE LEFT WITH HOMEOWNER TUB AND SHOWER VALVES Available with three or four port castings, with and without stops. Connections are either 1/2 inch I.P.S. pipe or 1/2 inch copper sweat connections. If the Moen Slip Fit spout is used, a 1/2 inch copper drop and lookout may be used. Measurements These are shown in the drawings. The depth measurement is critical. Use the front face of the plaster ground as a reference point for the finished wall position, including tile (2-1/16 [52mm]). The center line of the supply and discharge piping should be a maximum of 2-3/16 (56mm) and a minimum IMPORTANT: SEE FLUSHING of 1-7/16 (37mm) behind the finished wall surface. INSTRUCTIONS PAGE 2 TUB/SHOWER FINISHED WALL TUB FILLER COMBINATION LINE OR SHOWER 2-1/ 16 2-1/ 16