TM POTTING BENCH YellaWood（TM盆栽板凳YellaWood）.pdf

TM POTTING BENCH LUMBER 2 2” x 4” x 6’ YellaWood® brand treated lumber 2 2” x 4” x 8’ YellaWood® brand treated lumber 3 2” x 4” x 10’ YellaWood® brand treated lumber 9 5/4” x 6” x 8’ YellaWood® brand deck boards 1 1” diameter 2’2” Hardwood dowel FASTENERS AND HARDWARE 76 2-1/2” manufacturer recommended screws 146 2” manufacturer recommended screws 24 3/4” manufacturer recommended screws 3 12” shelf brackets 2 8” lawnmower wheels 1 1/2” diameter 3’ steel rod (axle) 2 1/2’’ axle hat nuts TOOLS SAFETY EQUIPMENT Power drill/screw driver Gloves 1” paddle bit Goggles 1/2” paddle bit Dust mask Hammer Hacksaw Circular saw/compound saw Tape measure TIP: Use water repellent or stain with water repellent when your job is finished to help protect your pressure treated wood from splitting, checking, and warping. Find your local YellaWood® dealer at YellaW CUTTING INSTRUCTIONS Start by cutting treated lumber to size. 1. Using two of the 10’ 2x4’s, cut 10 pieces to 21”. 2. Cut the third 10’ 2x4 into 2 pieces at 58’’ each (4’10’’). 3. Take one 8’ 2x4 and cut in half (2 pieces at 4’ each). 4. The second 8’ 2x4 should be cut to these two lengths: (a) one piece at 51” and (b) one piece at 42”. 5. Cut a 6’ 2x4 to these two lengths: (a) one piece at 36’’ and (b) one piece at 32-1/2’’. 6. The last 6’ 2x4 needs to be cut down to a length of 47-1/2’’. DRAWING A 7. Cut all nine decking boards (5/4’’ x 6’’) in half so that you (LOWER SHELF) have 18 pieces 4’ in length.