电池激活（Battery activation）.docVIP

电池激活（Battery activation） Battery activation processing: use a 5~6V DC voltage regulator source, current 500~600mA, reverse point contact the battery 2~3 times, after processing, and then use the original charger for adjustment period charging. The new lithium battery needs three full charge and discharge to fully activate it, and the first charge should be continuous for more than ten hours. The activation of a lithium battery must be accomplished without the overcharge protection circuit. Manage the battery production process: 1: battery shell filling electrolyte 2: sealing 3: formation (activation of the process: constant charge of the battery, and then discharge, so a few cycles, so that the electrode fully infiltrated electrolyte, fully activated, capacity to meet the requirements so far) 4: sub capacity (test battery capacity, selection of different performance (capacity) of the battery classification, division of battery grade, capacity matching, etc.) 5: Post tag factory Passivation of battery electrode Our conclusion is: to buy a new mobile phone battery does not need to be activated, not many people have time to do the first few times full ten hours, especially mobile phone only a friend, that means you have a period of time can not use the mobile phone. Battery and mobile phone manufacturers should take these problems into consideration. But if you are buying into the factory for a long time the battery (preferably not buy, because too long if the storage battery factory environment properly, even if the number of charge discharge cycles can not restore the capacity of the charge and discharge down) the necessary cycle is reasonable. Two 、 battery usage and maintenance The characteristics of the lithium battery determine its use is very convenient, and do not need to care whether it is used up and recharged. But the lithium battery is life, standards are generally charge and discharge times, it is recommended that you run out of power, the electricity cons