Standard Specifications for Architectural Cast （标准规范体系结构）.pdfVIP

Standard Specifications for Architectural Cast Stone Section 04-72-00-04 architectural cast stone Although a variety of casting methods are used, production conforming to this standard will exceed minimum requirements for compressive strength and weathering qualities essential for normal installations as a suitable replacement for natural cut limestone, brownstone, sandstone, bluestone, granite, slate, keystone, travertine and other natural building stones. It is hoped that this specification may be helpful to the specifiers in understanding the inherent qualities of Cast Stone and its use. For details and samples of finishes available in your project area, contact your nearest Cast Stone Institute® producer member. Part 1 General 1.1. Section Includes - Architectural Cast Stone.  Scope - All labor, materials and equipment to provide the Cast Stone shown on architectural drawings and as described in this specification. o Manufacturer shall comply with all material set forth in this specification. o Installing contractor shall unload, store, furnish all anchors if not supplied by manufacturer, set, patch, clean and seal (optional) the Cast Stone as required. 1.2. Related Sections  Section – 01 33 00 – Submittal Procedures.  Section – 04 05 13 – Masonry Mortaring.  Section – 04 05 16 – Masonry Grouting.  Section – 04 05 19 – Masonry Anchorage and Reinforcing.  Section – 07 90 00 – Joint Protection. 1.3. References  ACI 318 – Building Code Requirements for Reinforced Concrete.  ASTM A 185 - Standard Specification for Steel Welded Wire Reinforcement, Plain, for Concrete.  ASTM A 615/A 615M - Standard Specification for Deformed and Plain Billet-Steel Bars for Reinforced Concrete.  ASTM C 33 – Standard Specification for Concrete Aggregates.  ASTM C 150 - Standard Specification for Portland Cement.  ASTM C