SPECIFICATIONS FOR EXTRUDED ALUMINUM …（规范挤压铝u2026）.pdfVIP

SPECIFICATIONS FOR EXTRUDED ALUMINUM FLAT PANEL TYPE COVERS I. GENERAL A. Purpose This specification establishes minimum criteria for the design, fabrication and erection of aluminum flat panel covers and is applicable except as otherwise noted. B. Definition An aluminum flat panel cover is a system of individually removable, fully sealed aluminum panels supported around the perimeter of the tank rim and, when necessary, by aluminum beams and/or trusses, also supported by the tank rim. The panels are made up of reinforced extruded aluminum planks assembled edge to edge with a tongue and groove detail. Secured to the perimeter of the planks are specialized aluminum extrusions which allow the panels to be interlocked and sealed to each other. The planks are to be deeply textured to form a slip resistant surface. C. References The latest editions of the following codes and standards form a part of this specification to the extent specified herein: 1. ASCE 7 Minimum Design loads for Buildings and Other Structures. 2. ASTM C509 Standard Specifications for Cellular Elastomeric Preformed Gasket Sealing Material. 3. Aluminum Association Aluminum Design Manual, Specifications for Aluminum Structures, Allowable Stress Design, Eighth Edition, January, 2005. 4. AISI Stainless Steel Cold-Formed Structural Design Manual. 5. AWWA D-100 6. Federal Standard RR-G-1602 II. MANUFACTURER The aluminum flat panel cover system, as specified, shall be the product of a single manufacturer regularly engaged in the design, manufacture, and installation of this type of equipment, and shall be the Quad Seal Extruded Flat Panel Cover as manufactured by Ultraflote Corporation, H