SECTION 2 DIVISION 22 PLUMBING （第二节部门22日管道）.pdfVIP

University of North Carolina at Charlotte Design and Construction Manual Section 2, Division 22 – Plumbing SECTION 2 DIVISION 22 PLUMBING University of North Carolina at Charlotte Design and Construction Manual Section 2, Division 22 – Plumbing DIVISION 22 – PLUMBING Note: This is a guide for Designers only. Contents shall NOT be used in lieu of specifications as part of the Designer’s contract documents. PART 1 - PLUMBING GENERAL 1.1 PLUMBING DESIGNER: A. Design for Maintainability. Plumbing systems and systems components shall be durable and easy to maintain. The Consultants shall incorporate into equipment and system design sufficient access and clearance for maintenance, repairs, and replacement. Incorporate instrumentation necessary for balance and initial adjustment, as well as for service and monitoring. B. Design for Reliability. Systems shall have a high degree of reliability. If an entire building system will be affected by lesser reliability of a component (for example, a pump serving building process chilled water system), then a redundant piece of equipment shall be provided to increase overall system reliability. Design for parallel operation is acceptable for redundancy. C. Design for Energy Conservation. The energy efficiency of building systems and equipment is an essential part of the University design philosophy. Any new project shall be designed with state of the art energy efficiency. Design standards published by American Institute of Architecture (AIA), American Society of Heating Refrigeration and Air Conditioning Engineers (ASHRAE) and the State of North Carolina shall be met or