Instructions for Installation and Operation Type （安装说明和操作类型）.pdfVIP

Instructions for Installation and Operation Type UPM Unfiltered SCR Speed Controls for Permanent Magnet DC Brush Motors Model 0865, quick connect tabs for electrical connections Model 0866, plug-in terminal block for electrcial connections SPECIFICATIONS Input Voltage: 115/230 VAC +/- 10%, 50/60 Hz, single phase Max. Input Current: 8.2 Amps RMS at current limit with largest motor Output Voltage (115 VAC Input): 0-90 VDC Output Voltage (230 VAC Input): 0-90 VDC or 0-180 VDC Ambient Temperature: 0-50° C. Max. Output Current, Continuous: 2.1 Amps DC Max. Output Current, Peak: 5.1 Amps DC Speed Regulation: 1% of rated speed obtainable with most motors Acceleration Time: (0-90 VDC) Adjustable, 0.2-10 seconds Acceleration Time (0-180 VDC) Adjustable, 0.2-20 seconds Deceleration Time (90-0 VDC) Adjustable, 0.2-10 seconds Deceleration Time: (180-0 VDC) Adjustable, 0.2-20 seconds Means for Speed Adjustment: 10K ohm potentiometer or isolated 0-5 VDC signal Means for Drive Inhibit: switch closure Diagnostics: green power LED, red current limit LED R INSTALLATION WARNING: This control should only be installed by a qualified person familiar with its operation and associated hazards. The National Electrical Code (NEC), local electrical and safety codes, and when applicable, the Occupa