ESBE 3WAY VALVE Danfoss（ESBE 3路阀丹佛斯）.pdfVIP

Wiring: 91M, 92M, 92-2M and 93M for “Floating” Signals (see ). For ESBE 92P and 92K2 actuators, refer to the actuator’s installation instructions. ESBE 3-WAY VALVE Warning: Always turn off all electrical power before removing or servicing INSTALLATION INSTRUCTIONS the actuator. – The actuator is powered using a 24VAC transformer, 3VA minimum. Pipe the Valve into the System – Remove the four cover screws and lift the cover off the actuator. • ESBE 3-way valves can be piped for either 3-way Mixing or 3-way Diverting applications – Remove one (or two) of the wiring knockouts and install one (or two) of the • 3-way Mixing: 2 inputs, 1 output • 3-way Diverting: 1 input, 2 outputs “conduit fittings”. All wires must go through these fittings. – Attach the “common” from the control (or transformer) to terminal “N”. • The System port, or the port on the valve which will deliver the mixed water to the – Connect the control output for clockwise rotation to “Upper terminal L1”, and system, must never be the center port. connect the control output for counterclockwise rotation to “Lower terminal L1” • Install the valve so the actuator (if so equipped) will not be below the valve (ie. facing the floor). Auxiliary Switch – ESBE 91M, 92M, 92-2M and 93M actuators include one fully adjustable Orient the Valve Face Plate auxiliary switch. The wiring should be connected as shown in . To set the • The face plate can be turned ove