大形智能锂电池安全性说明讲稿.docx

安 全 检 测 报 告Test Report样品名称：铝壳锂离子电池NCLF 3.2V 8000mAhName of Sample: /检测报告Testing Center Test Report样品名称Name of Sample中文Chinese铝壳锂离子电池NCLF 3.2V 8000mAh英文English/样品编号Sample No1335454379生产单位Manufacturer上海动力储能电池系统工程技术有限公司Shanghai Power Energy Storage Battery System Engineering Tech. Co. Ltd检验方法Test method联合国《关于危险货物运输的建议书》UNITED NATIONS “Recommendations on the TRANSPORT OF DANGEROUS GOODS”判定标准Criterion联合国《关于危险货物运输的建议书》UNITED NATIONS “Recommendations on the TRANSPORT OF DANGEROUS GOODS”样品外观Appearance蓝色塑料包装Blue plastic package样品接受日期Accepted Date2016-09-13检测起讫日期Test Date2016-09-13~2016-09-13检测项目Test Items高度模拟；热测试；振动；冲击；外短路；碰撞；强制放电Altitude simulation; Thermal test; Vibration; Shock; External short circuit; Impact; Forced discharge检验结论Conclusion受检样品经过UN38.3项检测，检测结果合格。The samples has passed the test items of UN38.3.生效日期（Date）：2016-09-13备注Comment检测报告Testing Center Test Report序号No.检测项目Test Items测试方法Test Method本项结论Conclusion备注1高度模拟Altitude simulation将电芯和电池在温度为20±5℃、大气压力不大于11.6kpa的环境中贮存不少于6小时/Test cells and batteries shall be stores at a pressure of 11.6 kpa or less for at least six hours at ambient temperature (20±5℃)电芯和电池符合要求：无质量损失、无漏液、无冒烟、无分解、无破裂以及无着火现象；电芯或电池测试后的开路电压不低于测试前开路电压的90%。此项关于电压方面的要求不适用与完全放电后的电芯和电池。/Cells and batteries meet this requirement if there is no mass lost, no leakage, no venting, no disassembly, no rupture and no fire and if the open circuit voltage of each test cell or battery after testing is not less than 90% of its voltage immediately prior to this procedure. The requirement relating to voltage is not applicable to test cells and batteries at fully discharged states.合格Passed/2热测试Thermal test首先将样品放在75±2℃的环境中放置至少12个小时，然后放在-40±2℃的环境中放置至少12个小时。温度转换的最大间隔时间为30分钟。如此循环10次，最后将样品放在20±5℃的环境中静置24小时。/ Test cells and batteries shall be stored at least six hours at a test temperature equal to 75±2℃, followed by storage at least six hours at a test temperature equal to -40±2℃. The maximum time interval between test temperature extremes is 30 minute