不锈钢工艺（Stainless steel process）.docVIP

不锈钢工艺（Stainless steel process） The surface processing technology of surface processing technology for stainless steel surface processing technology of stainless steel surface processing technology of stainless steel of the ((((2222)))) which is a kind of metal removal process, in this process of stainless steel as anode in the electrolyte, the power is removed from the surface. The process is usually used for the processing of components because their shape is difficult to be polished by conventional methods. The process is often applied to the surface of cold-rolled steel sheets because their surface is smoother than the surface of the hot-rolled steel sheet. However, electrolytic polishing will make the surface of impurities more obvious, especially titanium and niobium stabilized material will be due to granular impurities make weld zone differences. Small welds and sharp edges can be removed by this process. The process focuses on surface protrusions and preferentially dissolves them. Electropolishing is the process of immersing stainless steel in heated liquids. The ratio of the liquid involves many proprietary technologies and patented technologies. The electrolytic polishing of austenitic stainless steel is very effective. 9. mesh surface processing, stainless steel can use a variety of patterns. The steel plate has the advantages of adding processing patterns or textured surface are as follows: to reduce the shrinkage of metal roofing materials (oilcan-ning), the term used to describe a bright surface of the terminology, this view of the surface uneven from the optical point. For example: a large area of decorative panels, even after stretching, straightening or tensile tension, it is difficult to make the surface completely flat, and thus will appear metal roofing material shrinkage. Moire patterns can reduce glare in the sun. If the pattern board has slight scratch and small area indentation, it is not obvious. Increase the strength of steel plate. Providi