hp110加墨水方法（Hp110 ink method）.docVIP

hp110加墨水方法（Hp110 ink method） 1, the upper part of the cartridge label torn off, saw five small volume below; 2, distinguish color, there is a hole for red, two holes for the blue, two holes for yellow (toothpicks can be inserted into the small hole to distinguish color); 3, the first paper towels or other hygroscopic good material pad on the table, in order to absorb the overflow of ink. 4, the cartridge label paper gently uncover (do not tear up, still need to be posted back), exposing the ink injection hole. Five holes in 5, under the label for arrangement of guide hole and an ink injection hole, hole to the light will distinguish three kinds of color ink will therefore position (if not good resolution can use toothpicks). 6. Remove plastic bottles containing blue (red or yellow) ink, open the bottle cap, remove the prepared syringe (carefully inserted), insert the needle into the plastic bottle full of ink, and suck the ink up. As the injection needle to discharge the air in, then the needle is inserted into the ink injection hole corresponding color, try a little deeper filling, ink consumption should be controlled in the cartridge ink capacity about 1/3 (each color can be 2ML). 7, hand ink (ink pouring hole upward) placed above the table, from top to bottom shaking cartridge two to three times. To fill the ink cartridge with ink. 6. Wipe the ink box nozzle with paper towel and affix the label paper back to its original place. Put the cartridge back to the printer for 2 to 3 times, print head cleaning, and then test, print, or test the nozzle. 8, in particular color cartridges should be careful about the operation in their own ink, the ink from the hole to avoid overflow to other holes caused by mixed color. Filling should pay attention to 4 points: 1, the ink cartridge must be in good condition again; 2. Please add ink as soon as possible after the cartridge is used so as not to leave it too long; 3, the key success is to choose the high quality ink ink and ink