平度春季居建材房产汽车团博会方案.doc

平度春季家居建材房产汽车团博会方案 时间：2013年4月20日——4月21日 地点：平度市中心-人民会堂广场、老年大学广场 主办：平度市新闻中心 平度在线 青岛正达企业策划有限公司 主题： 平度市春季家居建材房产汽车团博会 “2013开年大吉，喜迎开春装修旺季！” 集结买房者，让利价格，唤醒房市暖春！” “新车型，新品牌，价格惊爆你的眼球！” “各式家电，一站式够齐，享受最低价格优惠” 正规合法：必须是正规的厂家、代理商经销商供完整的企业执照、合格证、检验报告、获奖证明等文件和资料产品质量、服务和信誉须使用非燃或阻燃材料展位的内容由自行设计、制作。严禁携带易燃、易爆、易腐蚀、凶器等危险品进入展，不准存放、使用充压的压力容器。展台附近禁止使用碘钨灯、高压汞等高温灯具，各单位在展内不，人行通道、防火间距、出入口处必须保持畅通，消火栓要暴露，不得压、堵或损坏消防设施。 the same direction of rotation 90 ° or 180 ° for; after each disc rotor when measuring position alignment of the two half coupling constant, should also be in terms of accuracy and consistency. Surface deviation measurement, must in every 180 degrees corresponding to the two radii are equal to each other in order to eliminate errors caused by movement of the rotor. Only a support bearing of the rotor, WA couplings, such as the use of temporary leave the Center, should pay attention to keep the rotor in the measuring process in the center of the bearing oil retaining the nest does not change. Steam oil block, there should be sufficient clearance between the rotor and, in rotors make sure rotor is not on the block or seal oil. At the time of measurement, connections are not allowed between two rotors, each in a free State. Not allowed in case of assembled sleeve, Center work on the toothed coupling. Coupling tool should have adequate stiffness, installation must be secure and reliable. Coupling Center using a dial indicator, the table should be put in prison and avoid touching, to ensure correct measurement. Coupling disc after a week to return to the original position, circumference of dial gauge reading should be able to go back to the original value. When measuring the clearance of end, into the feeler of the gap should not exceed four at a time, when the gap is too large, you can use the gasket with the feeler gauge measurement of gauge blocks or finishing. bearing surface, markup should be in accordance with the mounting support pads, a