3.15消费者权益日策划书doc.docVIP

3.15消费者权益日 主办：共青团温州职业技术学院委员会 承办：温州职业技术学院学生会 二零一二年三月 目录 一、前言………………………………………………3 二、活动主题…………………………………………4 三、活动目…………………………………4 五、活动对象…………………………………………4 六、活动方式…………………………………………4 七、活动具体流程……………………………………4 八、活动要求及注意事项……………………………5 九、活动资金预算……………………………………6 十、传单设定…………………………………………6 十一、后记……………………………………………7 前 言 在近、现代商品经济条件下，消费者为争取社会公正，维护自身权益， 【活动主题】3.15维权在行动 【活动目的及意义】 此次活动，不但增加了同学们对的了解，也激发了他们意识。在认识环境中，知道。 /米 笔 传单 合计 浮动资金 总计 （注：以上所述时间如有变动，详见海报） 【传单设计】未定 后 记 本次活动有利于增强消费者的自我保护意识，促进大学生的维权意识“3.15国际消费者权益日”的宣传活动已经成为具有广泛的社会影响意义深远的社会性话题。 Ellipticity of elbow pipes with diameters less than or equal to 150 mm must be not greater than 8% diameter of 200 mm or less shall not be greater than 6%. Wall thickness of the pipe wall thinning rate must not exceed the original 15%. Crease roughness: diameter 125 mm or less, shall not exceed 3 mm diameter less than or equal to 200 mm, not more than 4 mm. 7.3.9 simmering bending production of square steel tube extension, to use the whole tube bending. Interface if necessary, the welding position should be located in the middle of the vertical arm. 7.3.10 install expansion joints should be done. If design is not required, pipe compensator lengthen should conform to the requirements in the following table: square scale length δ x is equal to 1/2. Pre stretch tolerance: casing + 5 mm, +10 mm. 7.3.11 pipe form, location, spacing shall meet the design and specifications. 7.3.12 piping on back or return pipe at higher levels of the upper to automatic valve to install a drain valve below the horizontal parts. 7.3.13 supports and hangers of checks and the number 1) hanger installed must be checked before installation of supports and hangers part models, specifications of springs setting values, whether the materials meet the requirements of drawings and documents; 2) supports and hangers of material, size and accuracy shall conform to the provisions of the design drawings, material technical requirements should be consistent with n