中国人民学集团管控课程-企业运营流程管控.doc

集团企业运营流程管控 上课时间：2015年11月14-15日 上课地点：中国人民大学汇贤大厦C座705室 讲师简介： 章义伍简历 ：著名经理人，实力派管理培训专家。在2001-2006年连续6年被评为“中国十大杰出培训师”，2007年被评为“十大领导力专家”，担任清华大学、北京大学、浙江大学、中山大学、中央党校等总裁班或EMBA班的特聘教授，美国领导力中心《情境领导》认证中文培训师，北京电视台《卓越之道》栏目主讲嘉宾报?名?回?执?表公司名称 是否上市公司 □是???????□否 单位性质 □政府机构?????□国有企业?????□民营企业????□外资企业????□其它(请注明:??????????????????) 联?系?人 性?别 手机 电话/传真 通讯地址 邮编 付款方式 □?电汇??????□?支票??????□?现金???????□?其他? 发票抬头 参会学员信息 姓名 部门 职务 电话、传真 手机 本次培训，你们最关注的问题是： 如有其他特殊情况，请在此说明： 联 系 人：逯老师联系方式在? 线QQ：1538080851传????真：010电子邮箱：jtgkceo@126.com the same direction of rotation 90 ° or 180 ° for; after each disc rotor when measuring position alignment of the two half coupling constant, should also be in terms of accuracy and consistency. Surface deviation measurement, must in every 180 degrees corresponding to the two radii are equal to each other in order to eliminate errors caused by movement of the rotor. Only a support bearing of the rotor, WA couplings, such as the use of temporary leave the Center, should pay attention to keep the rotor in the measuring process in the center of the bearing oil retaining the nest does not change. Steam oil block, there should be sufficient clearance between the rotor and, in rotors make sure rotor is not on the block or seal oil. At the time of measurement, connections are not allowed between two rotors, each in a free State. Not allowed in case of assembled sleeve, Center work on the toothed coupling. Coupling tool should have adequate stiffness, installation must be secure and reliable. Coupling Center using a dial indicator, the table should be put in prison and avoid touching, to ensure correct measurement. Coupling disc after a week to return to the original position, circumference of dial gauge reading should be able to go back to the original value. When measuring the clearance of end, into the feeler of the gap should not exceed four at a time, when the gap is too large, you can use the gasket with the feeler g