BASS KIT INSTRUCTIONS Kiesel Guitars（低音设备指令Kiesel吉他）.pdfVIP

CARVIN BASS KIT ASSEMBLY INSTRUCTIONS The components in this kit are the same as those used in Carvins high quality custom shop B4 and B5 basses. All holes are drilled, making it a simple step by step process to assemble your bass. Before you start assembling your bass, check the component check list to make sure that you got everything. Its also a good idea to read the complete instructions before getting started. Have fun! KIT COMPONENT CHECK LIST: neck. It is not necessary to coat the ebony fingerboard, although it wont Bolt-on bass neck hurt it. If you apply the tung oil onto the fingerboard, wipe off as much of Tuning keys the excess as possible within 5 minutes before it starts to dry. Wipe off Body the excess on the complete neck or body within 10 minutes. Now let the Combination bridge tailpiece neck or body dry for at least 5 hours before recoating with more tung oil. H50N humbucking bass pickups (2) You can hang the neck up to dry with a piece of wire through one of the Wiring harness tuning key holes. To hang the body to dry, run a piece of wire or string K2 knobs through one of the neck bolt holes. After the neck or body dries inspect BP1 rear electronics cover with threaded inserts it for sanding imperfections before applying another coat. Sand any JP1C jackplate imperfections out now with 320 grit sand paper.