IWAKI AMERICA MAGNETIC DRIVE AQUARIUM （磐美国磁驱动水族馆）.pdf

IWAKI AMERICA MAGNETIC DRIVE AQUARIUM PUMPS OPERATING INSTRUCTIONS INSTALLATION: 1. Remove plywood base and secure the pump to the floor or platform by bolting down the baseplate using all four bolt holes provided. A. If unable to bolt down the baseplate, place pump on a 1 inch thick foam pad to absorb vibration. 2. Check power source for proper voltage and phase. Plug the pump power cord into a switched, grounded outlet or hardwire into a properly grounded circuit. Use appropriate wiring materials and abide by all local and national standards for electrical codes. A. The MD series pumps do not include plug. Install grounded, three prong plug ( not supplied ) in accordance to plug manufacture’s instructions. 3. For optimal performance always install pump below the tank or sump. 4. Connect the inlet and outlet fittings of the pump with the appropriate size tubing or pipe connections. A. For tubing connections, use standard hose clamps to secure tubing. DO NOT OVER TIGHTEN B. For pipe thread connections, use pipe tape to insure a good seal. DO NOT OVER TIGHTEN. C. For convenient disconnection of pumps installed with rigid pipe, install unions near both inlet and outlet connections. D. All MD and WMD Series “Hi Flow” pump discharge ports are angled at approximately 30° off center. Flexible tubing is recommended for installing these pumps. E. Connection port horizontal to the baseplate is the inlet side. 5. DO NOT OPERATE PUMP DRY! A. Centrifugal pumps DO NOT have suction lift ability. Pu