vt300简单操作手册（Vt300 simple operation manual）.docVIP

vt300简单操作手册（Vt300 simple operation manual） Electrical training How the system works There are mainly manual (JOG), REF, semi-automatic (MDI), edit (EDIT), automatic (AUTO) Manual operation of the shafts, pins, pins, etc.. Refer back to the reference points after each spindle is turned on Semi-automatic - can perform individual program segments or other functions, such as hand punching. Edit - can fix, insert, delete, transfer programs Automatic executive stamping workpiece. 1. boot sequence (1) close the main power supply, so that the machine bus has electricity (2) press the POWER ON (power on) on the operation panel and wait for 30 seconds to display the monitor. The following alarm is shown: 1000, the reference point has not been returned, (3) start the motor according to the starting button of the oil pump, and the indicator light is on (4) select JOG (manual) mode (5) press the manual axis movement button - X, - Y, so that the X and Y axes are all apart from the origin 200MM (6) the mode is chosen as REF (return) mode (7) press the manual axis movement button +X, +Y, +T, make the X, Y, T axis back to the reference point, the indicator light is bright, and the feedback is completed (8) press the manual axis movement button +C, make the C axis return to the reference point, the indicator light is bright, and the feedback is completed (9) switch the foot switch with the foot, and close the clamp (10) check the clamp according to the clamp key in the REF (return) mode Note: when returning the reference only need to click the direction button, the machine will perform continuous homing action in the shaft to the reference point, not by RESET (reset) to stop. Detection of machine tool clamp, X axis coordinates must be in the position of reference point, and the detection by RESET (without reset) to stop, when each boot machine tools are needed to detect the clamp. After each move will have an emergency stop after the test clamp, also need to remember the test clamp!!