waves音频插件3.0（Waves audio plug-in 3）.docVIP

waves音频插件3.0（Waves audio plug-in 3） Recording tutorial -Waves audio plug-in 3 (last) Waves4.0 Download Waves4.0 cracking package First effect: AudioTrack (audio track) It is aimed at the ordinary audio tracks we usually see, and combines the 4 Effects of EQ, equalization, compression, and noise gates in three different ways. If youve used the T racks (parent tape processing software), youll find it very similar to the AudioTrack functionality. But the T-racks interface is much prettier. The following figure shows the interface of AudioTrack (audio track): After using it, your entire mix can stand on a solid foundation. In the balanced aspect, the specific operation and parameter settings can refer to the Ultrafunk--EQ effector. In compression, you can refer to Ultrafunks compression effector. In the Gate (noise gate) of several parameters, only Floor (base) is unfamiliar to us, not familiar with how to do, try to know. 1. Rel is abbreviated as Release (release). 2. Put the mouse on the button, the mouse will change into a two-way arrow, drag in this direction, you can directly adjust the corresponding value of the button. 3. If you feel a step wrong, click the UNDO button at the top left to cancel this step. 4. If you set the Output (output) up too much, the No Clip on the right (without clipping) will become Out Clip (overflow, clipping), and at the same time show more than that below. If you will now set a wave, you will see the level of the amplified signal and scrappy was cut off . 5. You can select a preset scheme in Setup A, click on the Setup A after the Setup B, and then call in a program, then compare the two schemes. Another click of A-B or B-A will unify the two scenarios. Second effects: C1 Compressor (C1 compressor) as follows: The left side is the compressed / extended level meter. The middle buttons are, respectively: Low Ref, low reflection, changed to peak reflection after clicking; Makeup, level compensation; Threshold, threshold; Ratio compression