tf卡提速办法（TF card speed increase method）.docVIP

tf卡提速办法（TF card speed increase method） I used in the forum software Geka Matsushita, found that speed is not stable TF ~ after speed software testing has obviously confirmed this point (interested friends can test), we teach you a convenient, formatting method and can make the stability of TF ~ 2G and below use FAT32 with FAT, 4G and above, but change formatting properties. I was also troubled by this problem, and do not use fast formatting. Just follow the direct input command form I send below. Ive been using it. Stability and speed are good. Im SDHCs 4G card. See todays mainstream burn card support FAT32, so start with the SANDISC 4G SDHC Class2 card, because FAT does not support more than 2G capacity. The initial use of the XP system formatted as FAT32, loaded into the DSTT kernel and the game, found that the speed is really slow, reading list and moving up and down the list is too slow to bear, no way, FAT into it. Sure enough, the grid into FAT after a lot faster, but as more and more games, over the 2G, the big problem comes, loaded game card dead! Try changing the DMA state before loading into the game, but you can successfully enter the game, but every time you change it, its a lot of trouble! Looking at it, I found that the XP system uses FAT32 to format my 4G card, using the unit size of 4K. No wonder its so slow! If you know the problem, there is a solution! Way： For 4G enabled cards, click XP system, start all programs - accessories - command prompt Enter format I: /fs:fat32 /a:32K command format (note the space, which I: said my card on the computer is a I disk drive, if you are in the E disk, into E:), enter, prompt label (11 characters; if not, according to ENTER), directly? enter the OK. - for the 8G or 8G above capacity card, we use the format I: /fs:fat32 /a:64K command format (note the space, which I: said my card on the computer is a I disk drive, if you are in the E disk, into E:), can further enhance the speed of. 16G uses 128k...... And so on