布莱克和德克尔BDERO100电源按键替代 - iFixit.PDF

Black and Decker BDERO1 Power Button Replacement Black and Decker BDERO100 Power Button Replacement This guide describes how to replace the power button from the BLACK and DECKER BDERO1 5 inch sander. Written By : Irene Zubillaga © iFixit — CC BY-NC-SA www.iFixit .com Page 1 of 7 Black and Decker BDERO1 Power Button Replacement INTRODUCTION This guide describes how to replace the power button from the BLACK and DECKER BDERO1 5 inch sander. The tools that you will need for this process are the TR2 Torx Security bit driver or equivalent, the nylon spudger the plastic opening tool TOOLS: T2 Torx Screwdriver (1) iFixit Opening Tools (1) Spudger (1) © iFixit — CC BY-NC-SA www.iFixit .com Page 2 of 7 Black and Decker BDERO1 Power Button Replacement Step 1 Chassis  Use the nylon spudger to remove the rubber ring from the filter attachment section.  The easiest way to do this is to place the spudger sideways and pulling out the ring. Step 2  Use the TR2 Torx Security bit driver to unscrew the five 18.75mm Phillips screws from the warning label side of the chassis. © iFixit — CC BY-NC-SA www.iFixit .com Page 3 of 7 Black and Decker BDERO1 Power Button Replacement Step 3  Grab the plastic opening tool and place it on the