局放IEEE Guide for partial discharge measurement in power switchgear.pdfVIP

IEEE Std 1291-1993 IEEE Guide for Partial Discharge Measurement in Power Switchgear Sponsor Switchgear Committee of the IEEE Power Engineering Society Approved March 18, 1993 IEEE Standards Board Approved August 30, 1993 American National Standards Institute Abstract: This guide defines methods of measuring partial discharges that may occur in energized power switchgear apparatus in flaws, voids, and interfaces of non-self-restoring insulation that may then result in dielectric failure of the switchgear. Guidance on instrumentation and calibration technique is also given. Keywords: calibration, corona, dielectric tests, partial discharge, switchgear The Institute of Electrical and Electronics Engineers, Inc. 345 East 47th Street, New York, NY 10017-2394, USA Copyright © 1993 by the Institute of Electrical and Electronics Engineers, Inc. All rights reserved. Published 1993. Printed in the United States of America ISBN 1-55937-306-7 No part of this publication may be reproduced in any form, in an electronic retrieval system or otherwise, without the prior written permission of the publisher. Authorized licensed use limited to: Tsinghua University Library. Downloaded on August 02,2015 at 02:57:44 UTC from IEEE Xplore. Restrictions apply. IEEE Standards documents are developed within the Technical Committees of the IEEE Societies and the Standards Coordinating Committees of the IEEE Standards Board. Members of the committees serve voluntarily and without compensation. They are not necessarily members of the Institute. The standards developed within IEEE represent a consensus of the broad expertise on the subject within the Institute as well as those activities outside of IEEE that have expressed an interest in participating in the development of the standard. Use of an IEEE Standard is wholly voluntary. The existence of an IEEE Standard does