主板跳线接法,也就是主板电源和指示灯的连接（Main board jumper connection, that is, the motherboard power and indicator light connection）.docVIP

主板跳线接法,也就是主板电源和指示灯的连接（Main board jumper connection, that is, the motherboard power and indicator light connection） Main board jumper connection, that is, the motherboard power and indicator light connection 1 power switch connection line When connecting the power switch connection line, first find the marked power from the panel panel wiring SW two pin plugs are white, brown two colors, and then inserted in the motherboard marked PWR SW or RWR is on the pin. 2 reset switch connection line Used to heat up a computer. When connecting, find the marked RESET first SW two pin plugs are white and blue two colors, and then inserted in the motherboard marked Reset SW or RSR is on the pin. 3 connection line of power indicator First find Power marked LED three pin plug, the middle of a line empty two missing, both ends are white and green two colors, and then insert it on the motherboard marked PWR LED or P LED on the pin. Remind: the power switch, the connection line and the reset switch, the connection line two, when inserts, may not need to pay attention to inserts the positive and negative question, how inserts may. But because the power indicator side wiring uses the luminous two stage tube to display the work and rest, therefore the connection is directional. On some boards, P will be marked LED+ and P LED-, we just connect the green end to the P LED+ pin, and the white line is connected to the P LED- on the pin. 4 hard disk indicator light connecting line First find marked H.D.D.LED of the two plug, the line is white, red two colors, insert it on the motherboard marked HDD LED or IED LED on the pin. Attention should be paid to orientation when inserting. The main board will be labeled HDD LED+ and HDD LED-, and the red end will be connected to the HDD LED+ pin, white insert marked HDD LED- on the pin. 5 speaker connector First find SPEAKER of the four pin plug, the middle two lines of vacant, both ends are red and black two colors, insert it on the motherboard marked w