加速开机方法（Accelerated boot method）.docVIP

加速开机方法（Accelerated boot method） Because there are so many reasons, I have to copy it. Please forgive me: Here are several settings to increase the boot speed. I used 1, 2, and 5. When I start the scroll bar, I enter the system in less than a lap. 1, disable idle IDE channels Acceleration principle: because the Windows XP system automatically detects the IDE device on the computer during startup, it closes the detection of idle IDE channels, thus accelerating system startup. However, there is a need to correct the mistakes that have been circulating on the Web: many people think its okay to simply disable unused IDE channels in BIOS, while others recommend closing them both in BIOS and in the system. First of all, the first method is fundamentally invalid, because all the BIOS independent monitoring computer hardware operating system XP can bypass the motherboard; the latter seems to make an unnecessary move. Therefore, only can be closed in the Windows XP system, in order to truly disable the idle IDE channel effect. [] the practice is as follows: right click my computer properties, then click the hardware and then click device manager, in which the open IDE ATA/PATA controller (different chips vary), and then into the primary and secondary IDE channel, select the advanced settings, find current transfer mode to not applicable one here (corresponding to the IDE channel is idle), will be the device type is set to no, ok. 2, manually set the IP address Acceleration principle: Windows XP system is developed on the basis of Windows 2000, so it supports rich network functions. In the Windows XP system will automatically detect whether the computer into the LAN in the boot, but general users are stand-alone Internet access, and in network connections are basically set to obtain IP address automatically. Thus, the system searches for the DHCP server to assign an IP address to the machine, but the average user is not configured at all. This results in each boot, the system