泉盛tg-uv2（Quansheng tg-uv2）.docVIP

泉盛tg-uv2（Quansheng tg-uv2） Quansheng TG-UV2 written statement looks professional but not intuitive and practical, most people do not understand. 1, this type of walkie talkie is a dual standby model, so after the boot, the screen will show two channels (Note: rather than channel), there will be two cases: A, a small arrow down, will be displayed in front of a channel, on the top of the main channel, below, indicating the following main channel, B, in the upper part of the screen shows DW, which means that the upper and lower two channels are not divided into the main and the second, and they are the dual waiting mode; 2, this walkie talkie has 3 modes of display: A, channel display mode B, frequency display mode C, dual standby mode In the above a, channel display mode and B, frequency display mode, can be changed to C, double waiting mode: According to the F and 9, the middle position of the top of the screen will display DW, that is now two channel double waiting mode, repeat the above operation, cancel the double waiting mode [set up radio, should only for a, B, channel display mode and frequency display mode to operate]; 3, the channel display mode, there are three kinds of circumstances: A, CH, the upper and lower channel number: that is, up and down are displayed as CH-- channel number (number) B, FR, up and down are channel number + frequency: that is, up and down are displayed as M channel number (frequency) frequency C, NA, which is shown as the M channel number (number) name, and is shown as the CH-- channel number (number) below In the channel display mode [Note: non frequency display mode], press F, 0, 5, screen display DSP.**, at this time press the up and down key, you can press the above prompt to select three different display modes of the channel; 4, in the channel display mode, you can edit the name of the main channel (Note: channel name, the initial default is empty) According to the F and BAND into the channel name editor, at this time, you can