31500462F01D500快速安装指南04.pdf

Precautions 注意事项 NOTE l This document aims to provide simple and distinctive guidelines for hardware installation. 本文档用于为设备硬件安装提供简明快捷的操作指导。 l This document does not describe operations for the pre-delivery installation of the internal cables and so on. Instead, this document describers only the operations for on-site installation. 本文档对于出厂前已完成的安装操作，如内部线缆安装不进行介绍，仅对现场安装涉及的操作进行介绍。 l The service module configuration of the F01D500 cabinet involves the UA5000, MA5600, MA5600T, and MA5603T. This document uses the integrated diagram of the UA5000 as an example. F01D500 机柜业务模块配置包括：UA5000 、MA5600 、MA5600T 、MA5603T ，本文档的整机图形以配置UA5000 为例。 Electrostatic Discharge 静电 Before touching the device, or holding the boards and IC chips, wear the ESD wrist strap to prevent the electrostatic discharge of the human body from damaging the sensitive components. Ensure that the other end of the anti-static wrist strap is well grounded. 在接触设备，手拿插板、单板、IC 芯片等之前，为防止人体静电损坏敏感元器件，必须佩戴防静电手腕，并将 防静电手腕的另一端良好接地。 Bundling Cables 绑扎线缆 The distance between cable ties or fiber binding straps inside the cabinet should be within 250 mm. (For subscriber cable，the distance is 200mm. ) 在机柜内部，线扣/光纤绑扎带的绑扎间隔不超过250mm 。（用户电缆在机柜内线扣的绑扎间隔不超过200mm 。） Affixing Labels/Tags 粘贴标签/ 标识牌 Affix the label or tag to the signal cable, 20 mm away from the connector. When the cable is placed vertically, the label or tag should point towards the right. When the cable is placed horizontally, the label or tag should point downwards. 标签/标识牌默认粘贴位置在距离连接器20mm 处，标签/标识牌在电缆上粘贴后长条形文字区域一律朝向右侧或 下侧。即：当电缆垂直布放时标签/标识牌朝向右；当电缆水平布放时标签/标识牌朝向下。 1 Tools for Installation 安装工具 Before you begin, get the following tools ready. 在安装前，请准备下面的工具： Tape measure Philips screwdriver Flathead screwdriver 长卷尺 十字螺丝刀 一字螺丝刀