设计制图规范(国外英文资料).docVIP

设计制图规范(国外英文资料) Design drawing specification 1. general provisions 1.1, purpose 1.1.1 standardization -- effectively improving the quality of decoration design; 1.1.2 standardization -- to improve the efficiency of decoration design; 1.1.3 networking - to facilitate standardized management and results sharing on the network. 1.2, scope of application 1.2.1 this specification applies to all engineering drawings and CAD drawings of all our engineering projects. 1.2.2 the construction drawings referred to in this specification are: floor plan, top drawing, elevation, structural node diagram, fittings, furniture drawings and hydraulic electrical renovation drawings, etc.. 1.3, work style 1.3.1 this specification is the unity of the style expressed in the drawing of the company, and does not advocate the individual drawing expression style. Engineering drawings are strictly in accordance with the state drawing standards for construction drawings. The expression of drawings should be clear, complete and consistent in all aspects of the drawings. 1.4, according to 1.4.1 the basic basis of this specification is GB/T500012001 unified standards for housing construction drawings, and if there is any difference, then the GB/T500012001 unified standard for building construction drawings shall prevail. 2. drawings sorting 2.1 order of construction drawings: 1, map cover 2. Design instructions 3. Drawings catalogue 4. Decorative construction drawings (floor plan, top view, elevation, sectional drawing, structural node diagram, detail drawing) 5, to the level of construction drawings, drainage plane reconstruction drawings 6, electrical reconstruction drawings 3. fonts 3.1 drawings, fonts: In addition to the bid and its special circumstances, the following font files should be taken as far as possible without using TureType fonts to speed up graphical display and reduce graphics files. There should be no more than four fonts in the same graphic file. The following font files are sta