加快计算机启动速度办法(国外英文资料).docVIP

加快计算机启动速度办法(国外英文资料) First, the BIOS optimization settings In the BIOS settings page we enter the Advanced BIOS Features option, move the cursor to Frist Boot Device option, click PageUP and PageDOWN option, the default value of Floppy, said this?? when the system will be the first to read from a floppy? Information, this will lengthen machine? Move time, minimize the floppy drive life. So we have to choose HDD-0 directly from the hard disk, so that it will move on for several seconds. In addition, for the Above 1MbMemoryTest in the BIOS setting, choose Disabled, and for QuickPowerOnSelftest, choose Enabled. In the Advanced Chipset Features set, the acceleration of the impact of the machine is very big, please pay more attention to. Change the Bank 0/1 DRAM Timing from 8ns/10ns to Fast or Turbo. Turbo is faster than Fast, but not very stable. Fast is recommended. If the memory is good, you can choose Turbo and try to change it back to Fast. For memory quality memory, it is recommended to set 2 in the SDRAM CAS Latency option so that it can be speeded up. Newer motherboards support AGP4X, and if your graphics card also supports AGP4X, then you can start this at AGP-4XMode, that is, Enabled, which will give you a better ability to display graphics cards and speed up the system. Two, move DMA mode to increase the speed of hard disk Drive the maximum transmission rate by UDMA/33, 66, 100, 66MB/s, 33MB/s technology is 100MB/s, theoretically is the IDE hard drive (here refers to the PIO MODE4 mode, the transmission rate is 16.6MB/s) 3 ~ 6 times the transmission rate, but in the Windows default settings, DMA is disabled, so we it must be open. The specific method is: to open the console system, the device administrator window, disk drive branch, double-click the UDMA hard disk icon, enter the properties - Settings - Options in the DMA in front of a V, and then click OK, close all dialog box, the computer can be heavy?. Three, remove the Windows boot logo. First you have to