LUKAO(国外英文资料).docVIP

LUKAO(国外英文资料) One. Get ready before you get on the bus 1. go around the car for a week to check the tire pressure. 2., to see whether or not impede traffic obstacles. 3., after a weeks ride, stand at the left front door and shout the report. 4. by the examiner or member shall be allowed to accompany, to open the door on the car. 5. enter the cab, close the door, and prepare the night light test. Two night light simulation exam When you hear the voice prompt, turn on the light switch that you want to turn on within 5 seconds. 1. the first sentence of the test begins: at night there is no street light, no lighting (within 5 seconds) 2. other lighting requirements: Please change the headlight to the high beam Turn on the high beam The night in the narrow and non motor vehicle Open the lamp Night and motor vehicle Open the lamp Travel with the car in the same direction at night Open the lamp The night through the chicane, crosswalk Alternate use of far, near lights, first high beam, and then back to near light Crossing at night without traffic lights Alternate use of far, near lights, first high beam, and then back to near light Night through the mountain, arch bridge Alternate use of far, near lights, first high beam, and then back to near light Foggy driving Turn on fog lights and warning lights Traffic accidents occur on the road at night, hindering traffic and difficult to move Turn on the light and the warning light 3. at the end of the light test, there is the following voice prompt: simulate the night exam, please turn off all lights (when you hear this voice prompt, turn off all the lights in 5 seconds) 4. the student who has passed the lighting test will have a voice prompt: please continue to finish the exam.. Enter the third item: please start.. Note: if you fail the first test, you will have second make-up tests on the spot and repeat the above. Evaluation criteria for night light simulation test The light cannot be turned on properly - 100 Use the high bea