ApplicationGuidelines应用指南1.CircuitDesign.PDFVIP

ALUMINUM ELECTROLYTIC CAPACITORS Application Guidelines 1 .電路設計中的注意事項 1. Circuit Design (1) 要在確認使用環境及安裝環境的基礎上，在電容 1) Please make sure the application and mounting conditions to 器的產品目錄或仕樣書、圖紙交貨申請書(以下簡 which the capacitor will be exposed to are within the conditions specified in the catalog or alternate product 稱交貨仕樣書)中規定的電容器額定性能的範圍內 specification (Referred to as specification here after). 進行設計。 (2)工作溫度及負荷紋波電流值不可超出產品目錄或 2) Operating temperature and applied ripple current shall be 交貨仕樣書中規定的範圍。 within the specification. 電容器不可在超出規定的上限溫度(最高使用溫度) The capacitor shall not be used in an ambient temperature 的環境下使用。 which exceeds the operating temperature specified in the specification. 不可施加超過負荷的紋波電流下使用。 Do not apply excessive current which exceeds the allowable ripple current. (3)進行電路設計時，請選擇與機器壽命相符適用的電 3) Appropriate capacitors which comply with the life requirement 容器。 of the products should be selected when designing the circuit. (4)電容器為極性電容器。 4) Aluminum electrolytic capacitors are polarized. 請確認有無連接反向電壓或交流電壓。 Make sure that no reverse voltage or AC voltage is applied to the capacitors. Please use bi-polar capacitors for a circuit that 在極性反轉電路中請選用雙極性電容