控制性详细规划CAD制图要求规定(国外英文资料).doc

控制性详细规划CAD制图要求规定(国外英文资料) This article is contributed by m55pro DOC documents may experience poor browsing on the WAP side. It is recommended that you first select TXT, or download the source file to the local view. Mapping requirements specify regulatory detailed planning requirements for CAD mapping Chengdu Institute of planning and design, August 2003 Requirements for width and width The control results are uniformly extended by A0 or A0, and the outer outline line of standard A0 is 1189mm (width) * 841mm (high), and the electronic data unit is 2378 * 1682 (1:2000). The extension of the graph shall be an integral multiple of 1/8 of the standard figure, as shown below: Extension multiples A0, A0+1/8, A0+2/8, A0+3/8, A0+4/8...... Drawing size 1189 * 8411338 * 8411487 * 8411635 * 8411784 * 841...... Electronic picture frame size (1189 x 841) * K (1338 * 841) * K (1487 * 841) * K (1635 * 841) * K (1784 * 841) * K...... Note: K is the coefficient of proportionality, 1:1000 is 1, 1:2000 is 2,....... Font requirements two, font requirements 1, fonts and fonts: a full set of control electronic documents fonts, in principle only allow the following 5 settings, in addition to these five fonts, the figure should not appear other font name. No. 12345 font name (text style name) Standard Arial font name English digital bold italics (font, name) (BOLD) _GB2312 Romantic with bold Arial italics The limit for various type default font is used for the title, legend, etc. to describe and sign map form, place names (unit name, river, road map, sign) and other alternate font is used for various engineering and land use control, proportion and Scale Parameter annotation annotation The way Note: the Height and Width factor parameters of the font can be changed according to different needs. If the required vertical font, the font name should be taken as the black 0, 0, 0, and regular, the corresponding font @ @ @ italics, bold, arial. 2, font size: Title: big title word high 25K to 30K;