南方灵锐S82_RTK简易操作说明(外国英文资料).docVIP

南方灵锐S82_RTK简易操作说明(国外英文资料) Note: this method only introduces single point correction in this method, which is usually done by single point correction in the case of four parameters or seven parameters. A. the base stand is on known points Select the benchmark stand erect in the known point, click next, input datum stand erect high point of the known coordinates and antenna, and select the antenna high form, after the input can click on the correction. The system will tell you if you are correct, and show the relevant help information, and the check is correct after the check is correct. B. the base station is on the unknown Select base station erection at unknown point and click next. Input current mobile station of known coordinates, the antenna height and high quantity way, again will mobile station on known neutral point and then click the correction, whether the system will prompt correction, ok. Note: if the current state is not fixed solution, will pop-up prompts, should choose no to end correction at this moment, such as precision state reaches fixed solution repeat the above process again. When the state reaches A fixed solution, use the shortcut A to start saving the data Southern spirit S82RTK operation procedure and using technique?? 2011-06-28 10:42:51 |? Classification: RTK measures |?? Label: |, small and medium size? To subscribe to One. The base station section ?? 1) base station installation ?? 1. The benchmark stand erect points on feet, installed base, then connect the benchmark station host by head placed on a pedestal, of the leveling (such as in unknown point, is roughly the leveling). Note: the base station erection points can be worn on known or unknown points, both of which can be used, but the steps differ when adjusting parameters. ????? Placed 2. The transmitting antenna and radio, connect the antenna with head in the other foot rack, the side of the station on foot frame, with the launch on the radio antenna cable, with a power supply ca