斑马标签打印机使用全过程（国外英文资料）.docVIP

斑马标签打印机使用全过程（国外英文资料） Zebra label printers use the whole process: Carbon tape and label installation The dotted line is the carbon belt installation path, the real line is the label path. The carbon strip is not easy to flake off after the rollback, and the smooth bottom paper is rolled back on the reel before loading, then the carbon tape. When installing the label, adjust the paper filter according to the width of the label. Press the head spring evenly, avoid the printer label running off. The first time you use a printer, you should test paper. 2. The control panel PAUSE button: PAUSE and start to print the FEED: take a sheet of paper CANCEL button: when the print data transmission to the printer, but do not need to print can press PAUSE first, and then press CANCEL until data off many times. CALIBRATE: label test. When installing a new specifications label, test label, various parameters to print properly. Methods: the PAUSE button first, then according to CALIBRATE test paper. The label has an accelerated process, indicating that the paper is correct. Note: the paper is rerolled and the carbon can not be rolled back. 3. The equipment debugging Way customers can choose according to their requirement to Print selected SETUP to set the Darkness -- -- -- -- -- -- -- -- -- -- -- -- temperature Tear off -- -- -- -- -- -- -- -- -- -- - the Label ripped from the Print Position mode -- -- -- -- -- -- -- -- -- -- PEEL off (torn from way) Media type -- -- -- -- -- -- -- -- -- NON - CONTINOUS (discontinuous paper) Print Method -- -- -- -- -- -- -- -- THERMAL TRANS (THERMAL transfer) Print Width -- -- -- -- -- -- -- -- -- Print Width List Formats -- -- -- -- -- -- -- -- format List SETUP -- -- -- -- -- -- -- -- -- -- set the List of Media and Ribbon Calibrate -- -- -- -- -- - measuring the paper and carbon Label Top -- -- -- -- -- -- -- -- -- -- - the Label Print Position at the Top of the regulation Left Position -- -- -- -- -- -- -- the Label Print Position adjustment on