分区表错误提示（国外英文资料）.docVIP

分区表错误提示（国外英文资料） The partition table error The error in the number 100-199 is a partition table error. # 100 - - the partition table is damaged Most main boot record (MBR) can contain only one extended partition, and each extended partition boot record (EPBR) only contains a pointer to other EPBR link. This error occurs when the partition table violates the above rules. At this point, we must reestablish a partitioned table without errors to solve this problem. # 104 - - there is no sector in the partition All partitions should contain sectors. Before using PartitionMagic, remove the split sector. # 105 - - the partition starts at the wrong boundary The disk partition table contains the wrong values. The PartitionMagic expects the partition to start and end within the correct magnetic column boundary. If not, the disk may have been partially damaged. In this case, if the PartitionMagic changes, the data can be lost. Thus, PartitionMagic will refuse to recognize any partitions on the hard disk. # 106 - - the partition does not start with the first sector and see the error # 105. # 107 -- -- -- -- -- - partition at the beginning of the disk after the end, if the partition errors to beyond the entity at the end position of the hard drive, this error occurs. This can occur if the hard drive has been used on a different computer, or has been paired with a different hard disk controller, or has changed the BIOS Settings value. # 108 - - the partition does not end at the end of the magnetic column and refer to the error # 105. # 109 - - the partition ends after the disk and see the error # 107. # 110 - - the number of inconsistent disk partitions in the partitioned table sector contains two inconsistent Numbers of hard disk sectors. This is a serious error if DOS and another operating system use the hard disk. Because DOS will use one of the description, and the other operating systems may use another description, once the partition almost fill state, data loss may occur.