IPCop全功能防火墙（国外英文资料）.docVIP

IPCop全功能防火墙（国外英文资料） Do-it-yourself IPCop fully functional firewall Second, firewall plus router software installation process Installation system As mentioned earlier, in this router we assemble ourselves, we select IPCop as its operating system. The operating system is based on the Linux system, and the operating system itself and its source code are freely available, as long as the GPL license agreement is followed. As to its source, we can from IPCop website to download, download address for /, you can find it from the website of the multiple versions, format is an ISO disc image file. Although is the combination of a set of operating system and application, but its volume is very small, only 41 MB, and you can use any cd-writing process to burn it into a boot CD, and there are another option available, namely the image file is a disk image, we can put it back to a partition. In our test, the computer that ACTS as a router is a boot from a floppy drive and the entire installation process is done through the network. In addition to using floppy disk boot and install the operating system from the Internet, we have one of the most simple and fastest installation, is to give the assembly of the router to install a CD or DVD drives, and then boot from the optical drive and install the operating system, now its time to look at the concrete operation process. The first job is the first thing to do after electric start system in the main board of the CMOS setup menu to change the order of the boot device, optical drive is boot device sequence must be in the first place. This set can be finished in a system BIOS menu of multiple locations, in accordance with the motherboard used by specific BIOS system is different, the specific setting method may have some small differences. However, the Settings for this parameter can be found in the BIOS system Advanced Setup Options or Advanced BIOS Setup. Figure 4: setting the cd-rom is the first boot device Change good after the BI