磁盘挂载（国外英文资料）.docVIP

磁盘挂载（国外英文资料） * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * Mount the steps: # fdisk -l # mkfs-t ext3-c/dev/SDB formatting commands # mount /dev/sdb/oradisk mount command The # df-h looks at the mount condition # vi/etc/fstab /dev/hda7 / data ext3 defaults 0 * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * Etc/fstab is the file that holds the static information of the file system. In the /etc/directory, you can view it with the command less /etc/fstab, and if you want to modify it, you can modify it with the command vi /etc/fstab. When the system startup, the system will automatically read the information from this file, and will automatically the file specified in the file system is mounted to the specified directory. Let me show you how to complete the information under this file. Under this file, were going to focus on its six domains: file system , mount point , type , options , dump , pass . The details of these six domains are detailed below. 1, the fie sysytem . This is used to specify the device name or block information for the file system you want to mount, or it can be a remote file system. Anyone who has done embedded Linux development may know the meaning of mount 192.168.1.56: /home/nfs/MNT/NFS / -o nolock (which can be other IP) commands. Its task is to mount the/home/NFS/directory on the remote host of 192.168.1.56 to the native/MNT/NFS/directory. If you want to write it in the /etc/fstab file, the file system should be filled in: / 192.168.1.56: / home/NFS /. If you want to put some equipment (device) is mounted on the unit, writing such as/dev/sda1, / dev/hda2 or/dev/cdrom, among them, the first serial hard disk/dev/sda1 said the first partition, and also can be the first SC