服装CAD-数字化仪设置（国外英文资料）.docVIP

服装CAD-数字化仪设置（国外英文资料） f94 Digital Settings: default classification 2009-04-18-17:52:17 reading 46 comments: large and medium size ET clothing software Digital Settings: 1.1 to start the digitizer menu: CD91200 type to aim the vernier spider silk menu on the SET UP (start) squares, progressive according to downstream target F, E button; The CD9910 is the SET UP block on which the vernier cross is pointed at the menu, and the F key downstream. 1.2 through repetition of the A key on the lower reaches of the A key to set up the bright and extinguishing state of the red indicator, the parameters are as follows: MODE FORMAT RES BAUD PARITY LF ECHO 6 0000100 111,100, 100, 100, 100, 100, 0, 0 Note: 0 - - - a red indicator for the cursor of the cursor 1 - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - Vernier spider silk should be aimed at the central part of each bar small squares, if when the cursor turns red, it means the bit is 1, if the red light goes out the bit is 0. You can change the state of the box by using the A key per cursor. When the status to 1 (red light), press the cursor A key once it into 0 (out) A red light, if we press A cursor A, and the bit to 1 (red light). It is not until the flash of the vernier red light is in line with the parameters. Set up is completed, the cursor spider silk on the menu to SAVE (SAVE area) 1 (parameters) of the central part, press the cursor A key, the digitizer di di two buzzer, digitizer parameter has been set up, at this time can be online and software. The link between PAD and hep 1) hardware connection (COM1 or other) 2) sea PuChu beginning. (open a digitizer - with the 16 key cursors, in turn, on top of a command area B press the cursor 0 0 2 E place. (please see attached operation manual of analog digital discussion content CALCOMP) 3) the digital device port for setting parameters in the PAD is the serial port 1 (that is, the port you are connecting to), t