得宝一体机的操作代码及错误代码（国外英文资料）.docVIP

得宝一体机的操作代码及错误代码（国外英文资料） The operating code of the depot machine and the wrong DP error display code Display mode The original for Timing sequence E001 The main motor (M1) is abnormal; The main motor substrate is not normal; The main substrate is not normal; The coding sensor (PS7) is not normal When the drum rotation indicates the light, the encoding sensor; (PS7) cant check the edges in one second E002 The electric motor (M2) is abnormal; The lifting cap sensor (PS9) is abnormal; The lower and lower limit sensors (MS6) are not normal; The driving substrate is abnormal; The main substrate is not normal; The elevator is not working properly When the lift motor (M2) is moving up in 9 seconds the lift is unable to reach the maximum self-check information indicating the light is on When the lift motor (M2) is moving down in 9 seconds the lift is unable to reach the lower limit and the self-check information indicates that the light is on E003 Cutting motor (M5) is abnormal; The cutting limit on the operating side (MS1) is not normal; In the non-operating side (MS2) the cutting limit is abnormal; The driving substrate is abnormal; The main substrate is not normal; The wax paper is partially jammed in the cutting device The cutting motor will not be able to reach the limit switch of the removable cutting tool in three seconds when cutting motor signal E004 The combination indicator is abnormal; The transformer device is not normal; The CCD is abnormal; The AD base is not normal; The main substrate is not normal Combined lamp brightness check, the amount of light received by CCD cannot reach the scale (only one light check, the power is closed) E005 The ink roller is not normal The motor will not touch the switch within 15 seconds of the motor driven signal E006 The pressure motor is not normal The motor fails to touch the switch within 25 seconds of the rotation of the contact motor E008 The 1 \ \ F baseboard device is not normal; The IPC1 \ \ F baseboard device is not no