安川L1000变频器调试指导说明（国外英文资料）.docVIP

安川L1000变频器调试指导说明（国外英文资料） The anchuan L1000 frequency converter debugging instructions One. Wiring instructions: Encoder PG card type pg-b3 for asynchronous motors, incremental, open circuit collector type, and anchuan G7, 12V, 0V, A, B, corresponding interface cn5-b, C. Encoder PG card type PG - X3 for synchronous motor, with yaskawa gl5-676 IP, encoder for line driven, signal as an A +, A -, B +, B -, + Z, Z -, power is 5 v, IP is 5 v, IG to 0 v. Note that there is a jump line, 12V and 5V with jumper wire selection, the corresponding interface cn5-b, C. It can be fitted with the codec, headman, 1321, and tookawa. PG card type PG - F3 for synchronous motor, Hyde han company ENDAT2.1/01, ENDAT2.2/01, frequency converter has three pins, CN5 -c, CN5 - B, CN5 - A, three export, if only A PG card, please insert on the top CN5 - C. Matches the hedham 1313 and 413 encoders. Pg-e3 is used for hedhanen ERN1387, 5V, maximum current 200 milliampere. M1 M2 running signal MA and MC fault signal, SN is the public end, 30KW no brake unit, 37kw need brake unit. Two. Variable frequency converter parameter specification Environment setting parameters: The A1-00 LCD operator displays the language selection 0: English 7: Chinese The access level of the A1-01 parameter is 0: you can set/monitor A1-01, A1-04, and also monitor U parameters 1: can only be set/monitoring A2-01 ∽ A2-32 2: can be set/monitor all parameters The A1-02 control mode selects the control mode of the converter. The synchronous motor selects 7 0: PG/f control 2: vector control without PG 3: PG vector control 7: pg-pgs PM vector A1-03 initializes the 2220 2 line initialization Application parameters: The b1-01 speed directive selects the 1 0 operator 1 to control the loop terminal The b1-02 run command selects the 1 0 operator 1 control loop terminal The b1-03 stop option stops a free taxi stop with a zero speed stop B1-14 phase sequence 0:1: standard phase sequence switch (motor direction of rotation is turn reverse