两台电脑组建局域网的方法（国外英文资料）.docVIP

两台电脑组建局域网的方法（国外英文资料） First, set both computers to automatically get IP addresses and DNS. Start a Modem by connecting a computer directly to the network line of the Modem, then check the computers IP address with the following command: ipconfig Press enter. Record this address, assuming it is , then your Modems network segment is 192.168.0. Then, the network line from the Modem will be connected to the routers upport (WAN port). Then, start the new router and connect the two computers to the two downstream ports of the router (LAN, any two of the four) Then, check the computers section: If the address of A is , then your routers network segment is 192.168.1.x, and the router address is . To this step, make sure that the Modem is not on the same network segment as the router. If the Modem network segment will be 192.168.1. J x, then, do you want to log in to your router management interface, change my LAN network segment address, the router hypothesis to 192.168.2. X, the address of the router instead. Save the Settings and restart the router. Now, confirm the downward mouth two computers are connected to the router (LAN), and then on each computer, run command prompt, enter the following two commands, respectively, in order to ensure that computers are the new IP address: 1. Ipconfig/release 2. The ipconfig/renew In this way, both machines can get on the Internet. Is very important, is to ensure that the two routing is not on a network segment, because I guess you could buy the same brand of the router, and the same brand of, often default LAN is a network segment. Good luck. Your mercury router is a wireless router There are two ways to connect to a LAN The first (no router) : connect two computers to the network line, set the IP of a computer to , and the other set to The subnet mask is so you can set up a LAN for two The second is the same as the IP , which sets up the router on the router connection Then the two computer IP address partitions choose to automa