PROE参数（国外英文资料）.docVIP

PROE参数（国外英文资料） There are seven different kinds of style point parameters in the pro/e WF. The length ratio - you can enter the digit to determine the location of the soft spot The length is the position of any digit in the total length of the line 3, the parameters range from 0 to l The distance from the flat base is easy to understand The lock is never moved again 6, Unchained relationships are no longer relevant Various system parameter descriptions for proe = = = to determine the system parameter of the quality attribute The mp_mass ( path ) is used to determine the quality The mp_volume ( path ) is used to determine the volume The mp_surf_area ( path ) is used to determine the surface area The mp_cg_x ( path , coord_sys, path) is used to determine the x-coordinate of the center of gravity The mp_cg_y ( path , coord_sys, path) is used to determine the y-coordinate of the center of gravity The mp_cg_z ( path , coord_sys, path) is used to determine the Z coordinate of the center of gravity The pro_unit_mass sets the quality default unit (unit_point, unit_ounce, unit_ton, unit_gram, unit_kill, unit_size) of all the new parts and components. The pro_unit_length sets the default length units for all new parts and components (unit_inch, unit_foot, unit_mm, unit_cm, unit_m) Pro_unit_sys specifies the default system unit for the new model. = = = = = = = = the system drawing parameter = = = d# shows the parameters in the drawing comment, where # is the size identifier. The link size is displayed in the drawing comment, and # is the size mark. The reference size is shown in the drawing comment, and # is the size mark. The number of instances in an array is displayed in the drawing comment, and # is the array id. g# shows the geometric tolerances in the drawing notes, where # is a geometric tolerance identifier. The user defined parameter values are displayed in the drawing comment. The att_cmp target parameter, which specifies the element parameters associated with the ann