结构柱马牙槎的砼量及模板计算(国外英文资料).docVIP

构造柱马牙槎的砼量及模板计算(国外英文资料) The amount of concrete and the template calculation of the structure of the conformation Noun explanation: The horses teeth are a kind of masonry for the brick wall. Horse tooth if have teeth if Damascus and pony teeth if two term, pony teeth if the point at which the wall of build by laying bricks or stones at leave if every skin out 1/4 brick, brick for later pick if when inserted into the corresponding brick. This kind of the handle is a straight handle, should not be used normally, if because of special reason must use, should be in the next section of the room that should be reserved pull the steel bar. Malaysia teeth if constructional column is used for seismic zone set brick wall with constructional column intersect method of masonry wall of build by laying bricks or stones in the reduction in every five long skin brick out 1/4 brick, stretched out on the number of skin and five skins, but also in accordance with the provisions, the reserved after reinforcement. The construction of the approach: According to the regulation, the joints of the masonry and the structure of the column should be built into a horses teeth, and the height of each horses teeth should not exceed 300mm, and the depth of the pit should be 50 to 60mm. Current masonry masonry blocks are generally used for the use of steam and gas concrete blocks, with a height of 250mm high in the height of the gas concrete block, just as a horse tooth. Masonry when the first brick should be recessed, bit of feet, and then in order to enter the same back masonry horse tooth if (if the bottom using lime-sand brick masonry, should also be seen as a horse teeth if sunken into the foot). No matter the horse tooth if sunken into the bulge, and at the same time will drop hanging vertical with lines, horse tooth if should put the whole face of brick masonry interface, block cut surface should be kept in the side, make sure if beautiful horse teeth. According to the regulation, the steel b