木模板(含竹胶合板)装置与除去(国外英文资料).docVIP

木模板(含竹胶合板)安装与拆除(国外英文资料) According to the standard of quality acceptance of concrete structures, GB50204-2002, the black body parts are mandatory and must be strictly enforced. First, preparation for construction 1. The material (1) wood stencil (or bamboo plywood) : its specification and type must meet the requirements of the construction specification. (2) wood: the specification and type of the wood shall conform to the design requirements of the template. (3) support system: wooden brackets or various molding trusses, pillars, brackets, fixtures, bolts, steel door frames, crossbars, steel pipes, etc. 2. The operation conditions (1) the design of the template has been completed, with the design drawing of the template. (2) wood template preparation: the number of templates should be divided by the design of the template and the section of the construction flow, and the quantity of the template shall be rationally determined. (3) the stencil is applied to the mould, and the specification is piled up. According to the drawing requirements, the line of line and the edge of the template shall be set, and the level control shall be fixed. (5) the wall, the column of steel and steel, the water and steel pipe and the embedded parts have been installed, the protection layer of the steel reinforcement is fastened, and the hidden acceptance procedures are completed. Second, the operation craft 1. The column template Column (1) according to the drawing size production side template (note: the lateral plate width to increase twice inside thick plate template), according to the installation template pay-off nail location good pressure foot again, add two vertical suspension roof support, the perpendicularity of the correction and diagonal pillars. (2) install column hoop: column hoop should be based on factors such as size of mould, and the size of the lateral pressure on design choices (wooden hoops, hoops and steel band, etc.), column hoop spacing is in commonly 500 mm or s