施工组织课程设计(含横道图战争面安排图)(国外英文资料).doc

施工组织课程设计(含横道图和平面布置图)(国外英文资料) Choose between 8 n/mm ^ 2, chose the too low or too high pressure, coating quality is poor, paint loss. The jet range is 40-60cm, the nozzle is parallel to the wall and the running speed is consistent. Spray construction hope to be continuous work, one breath to be able to get to the dividing seam to stop. C, doors and Windows project A, doors and Windows are wood and Windows and aluminum alloy. B, elastic line to find rules: external window, find window to the top position, on the basis of their edges, respectively using theodolite drew Windows and doors under the edge, and completes the tag, the individual is not straight cut processing, stuck between the mouth of the horizontal position of doors and Windows should on the basis of floor + 1000 level, counter measure up offline window, door and window width of allowable deviation plus or minus 5 mm, 5 mm height. C, doors and Windows should comply with the design requirements of specification, classifying size stacked, standard level for installation, doors and Windows components require installation is firm, and make the protection of the semi-finished products, prevent paint mortar bond to the doors and Windows. D, wood frame around the side of anticorrosive processing, according to the requirements of design, model steel window fittings, such as pieces of fixed installation with metal parts, in addition to the stainless steel galvanized processing. (4) technical quality measures (1) before the construction, the paper will be carefully prepared for the examination of drawings and the technical background, and the construction principle of the drawing shall be carried out correctly. To solve the problems of the errors in the drawing, the part of the handover, the unreasonable design and the material substitution, etc. Strict control of design changes and material substitution, and all project changes and materials shall be issued by the design institute for the official change of notic