水泵保养程序.docVIP

水泵保养程序 水泵保养程序作者：佚名 时间：2017-8-11 浏览量： .0目的:确保水泵正常运行。 适用范围:生活水泵、消防水泵等各类水泵。 职责: 专业公司按公司规定周期进行维修保养与记录。 分公司主管领导审核。 公司工程部查验。 内容: 保养周期规定: 生活水泵的运行泵与备用泵应互相轮换运行,每半月至少轮换一次。 生活水泵、热循环水泵每月进行一次一般性保养,半年进行一次全面保养。 消防泵、喷洒泵、补压泵每半年进行一次全面保养。 与泵体相连的5米范围内阀门、压力表、管道等随泵体同时保养。 保养规范: 泵体: a.检查润滑油质量、油量是否符合规定,不足应及时加油,如发现油质变色、有铁屑应将润滑油全部更换。 b.检查盘根松紧程度:滴水是否符合规定;体会各紧固件是否牢靠、无松动。 c.泵体无渗水、溢水、沙眼,泵轴渗水无流到地面。 d.检查泵轴转动灵活,泵轴与电机轴在同一中心线,机座紧固、螺丝无锈蚀,垫片齐。 e.外观整洁,油漆完好,标志清楚。 阀门、管道、接头附件: a.阀门开关灵活,关闭严密,无漏水。 b.阀体、手柄完好,阀杆润滑好,外观整洁。 c.单向阀动作灵活,无漏水。 d.检查压力表:压力表指针灵活,指示准确,紧固良好,表阀及接头无渗水。 电器: a.电机外观整洁,铭牌清晰,各部件紧固,联轴器保护罩完好,接地良好。 b.测量绕组绝缘:绝缘符合规定。 c.电机端子板联接片连接可靠,接触良好,无发热变色迹象,外部引出线无松动。 d.电机控制部分:线路整洁,接触器触点接触良好,若触头严重烧蚀,即应更换触头。操作手柄完好,位置指示正确。 运转: a.点动起动三次,观察水泵转向及起动电流、信号、显示正常后,方可投入正常运行。 b.水泵投入运行后,水泵输出水压应正常,各部分运转应平稳、无跳动、无明显振动、无异声,压力表指示稳定,三相电流平衡度小于2%,转速、电流接近额定值。 相关文件及记录 《Ⅰ、Ⅱ级设备保养记录》 Measures for the routine management of moral education in Middle SchoolsMethod of conventional management of moral education in middle schoolFirst, the guiding ideology:School moral education is an organic whole of the whole education work, always adhere to the school adhere to the moral education, education for this product, and actively promote the quality education, the school building efficient curriculum system of moral education, moral education, improve the sense of attraction and appeal, enhance the moral education work for through and timeliness. Teach everyone, service education and management education, and school moral education work must be with family education and community education closely together, to form a concerted pattern, and strive to create a good atmosphere for education, and to promote the all-round development of students, to establish a scientific moral education full of vigor the For long-term mechanism.Two, the goal of moral education:To guide the students to form the correct world outlook, outlook on life, values, to cultivate students unity and mutual assistance, honest and trustwor