PoweredIndustrialLiftTruckGeneralKnowledge,Operation,.pptVIP

Refueling and Recharging Refueling LP (Liquid Propane) Lift Trucks  * Before replacing an LP gas tank, close the shut off valve and let the engine run until it stalls. * Turn off the engine and any lights that may be on the lift truck. * Check for damage to connections and look for leaks. * WARNING: Since LP gas is heavier than air, make sure there is plenty of ventilation before changing or refilling LP tanks. * Do not smoke; make sure there are no open flames near the lift truck. * Ensure the centering pin is alligned correctly with the fuel cylinder before re-attaching fuel lines Refueling and Recharging Recharging Electric Lift Trucks  * Turn off the motor and any lights that may be on the lift truck. * Do not smoke; make sure there are no open flames nearby. * During the recharging process, batteries give off hydrogen gas. Make sure you recharge your battery in a well ventilated area. * Be careful not to spill any battery acid (electrolyte). If you do, clean it up using an absorbent material. * Because of the danger of electrical arcing, which will ignite hydrogen gas, keep tools and other metal objects away from the top of uncovered batteries. This includes rings and watches. * Batteries, when they are recharging, produce heat. Be sure to keep the compartment lid open. * Wear all prescribed safety equipment (face shield, rubber gloves, rubber apron, etc.). Refueling and Recharging Changing Batteries If you are responsible for changing the battery on your lift truck, you should: * Wear an apron, gloves, and face shield or goggles. * Use a non-metallic boom or lift device to prevent sparking. * Make sure there is an eye-wash station nearby. * Securely strap the battery into place before operating the lift truck. Refresher Training Evaluation Per Oregon Administrative Rules (OAR), Chapter 437 (Oregon OSHA), Division 2 (29 CFR 1910 – General Industry), Subdivision N: Material Handling and Storage: Refresher training in re