空气悬挂打气泵.pdfVIP

Audi allroad compressor 01-06 1. The compressor is located in front of the 2. Remove the protective cover from the spare tire well underneath the car. underside of the compressor via the three mounting studs. 3. With the three nuts removed, remove the 4. The compressor is held on with three cover to expose the compressor. nuts, one on each isolator. Isolators will be reused on the new assembly. 5. Disconnect the three electrical plugs, 6. Remove the old compressor from the car. airline and intake air hose from the compressor. One plug is on the solenoid while the other two are positioned to the right. Rev-02 01-17-09 Audi allroad compressor 01-06 7. Remove the power cord, thermal sensor 8. Attach the air intake tube to the new and intake tube from the old compressor. compressor assembly. PUSH DOWN ON THE BLACK RING WHILE PULLING OUT ON THE INTAKE TUBE FOR REMOVAL. 9. Loosen and remove the head bolt of the 10. Place the thermal switch in place on the replacement compressor, as shown. new compressor and retighten head bolt. 11. Strip the ends of the power cord wires 12. Completed unit ready for installation in and crimp them to the terminated ends. the reverse of steps 6-1. Rev-02 01-17-09